Traffic Light Controller with Pedestrian Request

Microsoft
Intel

Problem Description

ChatGPT Image Aug 1, 2026, 04_09_55 PM

Design a traffic light FSM that normally cycles GREEN (4 cycles) -> YELLOW (2 cycles) -> RED (4 cycles) -> back to GREEN, repeating forever. If ped_req is pulsed while the light is GREEN, the FSM must still finish the current GREEN duration (for safety, it doesn't cut green short), then go through YELLOW as normal, then hold RED for an EXTENDED 6 cycles (instead of 4) with ped_walk asserted for the first 4 of those 6 RED cycles, giving pedestrians a safe walk window. If ped_req arrives during YELLOW or RED, it's captured and honored on the very next RED phase. If no ped_req was captured, RED lasts the normal 4 cycles and ped_walk stays low throughout.

Interface Table

Port

Direction

Width

Description

clk

input

1-bit

Positive-edge triggered clock

reset

input

1-bit

Active-high synchronous reset; goes to GREEN, count=0

ped_req

input

1-bit

Pulse; captured any time, honored on the next RED phase

light

output

2-bit

Registered: 00=RED, 01=YELLOW, 10=GREEN

ped_walk

output

1-bit

Registered; high during first 4 cycles of an extended RED


Edge Cases

  • ped_req pulses during GREEN → GREEN still completes its full 4 cycles (not cut short)

  • ped_req pulses during RED itself (after RED has already started) → NOT honored this RED phase, must wait for the next RED phase

  • Multiple ped_req pulses before the next RED → treated as a single request (no queuing/counting)

  • reset fires mid-cycle → immediately returns to GREEN, count and pending request clear

  • No ped_req ever → RED is always exactly 4 cycles, ped_walk never asserts

All Scenarios

Scenario

Key State

Output fires?

Normal cycle, no ped_req

GREEN→YEL→RED(4)

ped_walk=0 throughout ✗

ped_req during GREEN → next RED extended

RED(6)

ped_walk=1 for 4 cycles ✓

ped_req during RED itself (too late)

pending cleared

honored NEXT red only ✗

Reset mid-FSM

GREEN, count=0

ped_walk=0 ✗

ped_req pulsed twice before RED

single request

ped_walk=1 once, not doubled ✓

Verilog

Code Editor Access

Log in to write, run and submit your solution to this interview question. It's free.

Output

Output goes here...